There is no LED light indicator (circled in below) to signify which resolution is selected. The front panel “RES” button is very difficult to use.The DIRECTV box will lose its setting once you unplug the power, so if you move the box to another location, you will need to reconfigure the resolution again.Here are some strange behaviors to look out for when using the DIRECTV box: You will see the screen shows 720p, then you can connect it to our media player: You will need to connect it to a screen, then switch the resolution to 720p by pressing the “RES” button on the front panel. The DIRECTV box outputs a 480i resolution by default (which is not support by our XMP-6400). If it still shows “Out of Range”, then repeat “step b” until you see an image show up on the screen.Press 2 times on the RES button, then wait for 5 seconds.Connect DirectTV box to XMP-6400’s input.If you are experiencing an issue or “Out of Range” when connecting your DIRECTV Model H24-700 cable box into our XMP-6400, the solution is to change the output resolution using DIRECTV box’s front panel button instead of using the remote control.įollow the following instructions to configure the DIRECTV H24-700 box:
0 Comments
Leave a Reply. |